Installation guide
Drilled and no-drill steps, plus wall fitting notes
Installation guide
The basics in 3 minutes
Tools to prepare
Tape measure
Pencil
Spirit level
Drill
Screwdriver
Marker
Installation steps
01
Mark the position
- Set the installation area and centre line, avoiding doors, cabinets and sockets.
- Use a spirit level to confirm the line, so the panel does not sit visibly tilted.
- Mark drilling points on the wall using the panel's holes; four to six fixing points is typical.
- Recheck hole spacing and edge margins for both visual proportion and structural safety.
02
Drill and fix
- Choose the drill bit and fixings for the wall material; 6 mm or 8 mm is typical.
- Drill vertically at the marked points, slightly deeper than the anchor length.
- Tap the anchors in until flush with the wall.
- Align the panel over the holes, fix it, then check each screw for even load.
Note:Drilled fixing suits concrete and brick for long-term use; if you hit rebar, pipework or wiring, stop immediately and reposition.
03
Check and adjust
- Check every screw is tight and the panel does not wobble.
- Recheck the panel with the spirit level.
- Fit a few accessories first to test the load, then add everyday items gradually.
- Clean up drilling dust and keep spare accessories for later changes.
No-drill installation
No-drill mounting suits verified smooth substrates and light use only; feasibility and load boundaries depend on adhesive, board type, substrate condition and curing.
- Clean the wall; remove grease, dust and moisture.
- Apply adhesive or mounting tape to the four corners and centre of the panel back.
- Press and temporarily secure according to the adhesive or mounting product instructions.
- Wait the full curing time, then load lightly and keep observing.
Contact us
To confirm wall suitability, load boundaries, mounting method or care, reach us below.